How to apply Vinyl Labels and Decals
  • The surface you are applying the vinyl on must be completely clean and dry. Make sure your wall is free of dust, oil and dirt

  • Make sure your hands are clean and dry before handling the vinyl

  • Remove backing from vinyl, exposing the adhesive leaving the transfer paper in place. Be very careful and slow when doing this to make sure you do not tear the vinyl in the process. If at any time the vinyl does not want to come off the backing paper, push down the paper again in that spot, then rub vinyl with your finger and try pulling off again. For more stubborn vinyl, try lifting the edge of the vinyl with your fingernail.

  • Once backing paper is removed, arrange design on desired surface from centre of the letters first andwork your way out. Press down firmly with a flat tool (a credit card or similar) over entire label/decal to affix and remove any air bubbles.

  • Peel away transfer paper slowly and gently at angle starting from the top and pulling down. If the letters of your vinyl or decal start to lift with the transfer sheet, lay it back down and press down on the area again (using credit card or similar) until vinyl is affixed on the surface.